2022.07.14
1. Classification of EPS foaming machines
There are many brands and models of foaming machines, but according to the foaming principle, there are only three widely used types: high-speed impeller type, high-pressure air type, and medium and low pressure blast type. The difference of the same type is only the difference between its ancillary equipment and automatic control. The structure of the foamed part is basically the same.
Second, the principle of EPS foaming machine
The basic principle of foaming is to introduce air into the foaming agent solution, no matter what kind of foaming machine it is. The variation of different models is that the effect is different, and the way of introducing the gas is also different.
EPS foaming machine classification, principle and process
There are two necessary factors for the formation of foam, one is the foaming agent solution, and the other is air, these two factors are inseparable. Without a blowing agent solution, no liquid film will form around the gas, and there will be no bubbles. Without gas, foaming agent solutions alone cannot form foams.
In the bubble formation system, the gas is the dispersed phase, the gas is dispersed in the liquid to form bubbles, the foaming agent solution is the dispersion medium, and many bubbles form bubbles. In addition to the properties of the blowing agent, the introduction of gas in the blowing agent solution is also an important factor. The foaming machine adopts a certain method to introduce gas into the liquid, that is, the introduction of gas into the liquid must be completed by the foaming machine.
3. EPS foaming machine process
1. Feeding and mixing: Add the cement, foaming agent, and classification, principle, and process strength of the EPS foaming machine to the mixer through the feeding system, and dry mix for 30 seconds. ;
2. Stirring: Add the warm water for the classification, principle and process of the EPS foaming machine into the mixer, and stir for 2 minutes; add the foaming agent for the classification, principle and process of the EPS foaming machine to the mixer and stir for 8-15 seconds;
3. Injection foaming: Immediately inject the slurry into the mold for foaming;
4 Initial curing: After the injection molding is completed, let it stand for several hours for initial curing;
5 Demoulding: the initial setting of the foam cement insulation board is completed, and demoulding after reaching the initial strength;
6 Cutting: After demoulding, a certain strength of foamed cement insulation board blanks can be cut, and the cutting specifications can be adjusted according to the needs of the cutting blade;
7 Finished product maintenance: The maintenance cycle is not less than 7 days.
Tel:
English 
