2022.05.10
The eps foam cutting machine uses the cutting control system in the PC to control the X-axis and Y-axis of the machine tool to move up and down, left and right, so as to drive the device with the heating wire arm to complete the two-dimensional graphics cutting with its movement. The European-style component cutting machine can cut a variety of related grooves on one device, such as large and small dovetail grooves, T-shaped grooves, rectangular grooves, arc grooves, corrugated grooves, etc.
The features of the foam cutting machine are as follows:
1. It adopts graphic input method, which is more intuitive than code input, and the operation is fast and convenient.
2, Chinese interface, suitable for China’s national conditions.
3. Diversified input methods, all debugging control instructions (the entire process of automatic cutting, such as initial positioning, arc striking, perforation, cutting, returning to the origin, etc. are completed under the command of CNC automation, and its parameters can be modified through programming) .
Structural features of CNC foam cutting machine:
1. The movable worktable adopts the negative pressure adsorption method to fix the cut foam.
2. Equipped with a movable cutting material adjusting device. In order to ensure the dimensional accuracy of the cutting material, it is equipped with a digital display ruler.
3. The red brake button is used for manual braking. This button has no effect when the start button is pressed.
4. When it stops running, it is equipped with manual and automatic devices.
5. When the brake electromagnet is engaged, press the start button, and the brake electromagnet will be released immediately.
The operations that Eps CNC foam cutting machine needs to pay attention to during the cutting process:
1. Turn on the switch in the power distribution cabinet;
2. Open the power lock on the operation panel, press the power button to supply power to the CNC; turn on the power supply of the dust collector, and check whether the indicator light on the control box panel is normal;
3. CNC performs internal self-diagnosis to confirm that no error message is displayed;
4. Turn on the switch in the servo cabinet, press the servo ON button on the operation panel to supply power to the servo system, turn the pulse knob on the control cabinet panel to the ON position to recoil the filter cartridge, and check whether the pulse is normal;
5. Trial operation to confirm that the switches and buttons on the panel are flexible and reliable to check whether the ash discharge flapper valve is normal;
6. Test run the machine to confirm that the machine runs smoothly, and the limit and emergency buttons are reliable.
Tel:
English 
