2023.05.24
Polyurethane high pressure foaming machine features:
1. The pouring volume of the pouring machine can be adjusted from 0 to the maximum, and the adjustment accuracy is 1%.
2. This product is equipped with a temperature control system. When the specified temperature is reached, the heating can be stopped automatically, and the control accuracy can reach 1%.
3. The machine has a solvent cleaning and blowing system.
4. The machine is equipped with an automatic feeding device, which can feed materials at any time. A and B barrels can hold 120 kg of liquid. Water Jacket A liquid or water jacket that contains a cooling water jacket. Each bucket has a water sight tube and a material sight tube.
5. This machine adopts the cut-off door to adjust the ratio of A and B materials, and the batching accuracy can reach 1%.
6. The customer provides a set of air compressor, the pressure can be adjusted to 0.8-0.9mpa.
7. Time control system, the machine control time can be set between 0-99.9 seconds, and the accuracy can reach 1%.
Use of polyurethane high pressure foaming machine:
1. The product voltage is 380V, using three-phase four-wire system. The user can turn on the power according to the specified direction of the pump.
2. Before use, add water to the water jackets of the two water storage tanks and the gas storage tank, and the pipeline is not used as a standard.
3. To feed liquid A and B of the pouring machine, open the automatic feeding door and turn on the automatic feeding switch to complete the automatic feeding procedure.
4. Set a certain time on the relay of the pouring machine, then open the cut-off door of the test material port, turn on the automatic feeding switch, weigh the weight of the material and the weight difference within the set time, and adjust the two Cut off the station so that the proportions are balanced to meet the job requirements.
5. The pouring time can be set between 0-99.9 seconds, and the setting accuracy is 1%.
6. After the pouring trigger is turned on, turn on the pouring switch. When the set working time is reached, it will stop automatically. However, the air supply should be automatic for 3-5 seconds to flush remaining material. Turn off the wrench switch, flush the tip with water and air, and the job is done.
Precautions for the use of polyurethane high pressure foaming machine:
1. Water should be added to the water jacket of the bucket before use, and it should be drained in time when it is not used in winter.
2. Be careful not to add the wrong materials A and B when feeding the liquid, so as not to damage the machine and cause accidents.
3. When the pouring machine is out of service, the gun head must be cleaned for future use.
Tel:
English 
