2022.05.05
The computer equipped with the EPS line cutting machine is equipped with software in the system, and the data can be downloaded, imported and transmitted directly, which is easy to operate.
The walking parts of the EPS line cutting machine are driven by gears and racks without gaps, and the motor drive adopts advanced driving technology; the control system has all Chinese and English interfaces, the operation is simple and convenient, and the U disk is imported into CAD graphics for direct cutting; programmable cutting of straight lines and arcs Parts of any flat shape.
Before use, turn on the main switch and turn it several times for a no-load test until it is safe to start.
Before running the EPS line cutting machine equipment, it is necessary to check whether the power supply meets the rated voltage of the equipment, so as not to connect the power supply by mistake, and the saw blade with the rated speed less than 4800rpm cannot be used.
The EPS wire cutting machine must be stable and the grip type cutting machine should cut vertically with equal force, and the fixed end should be firm and reliable.
Do not attempt to cut small unclamped workpieces or profiles with severe edges (if the outer diameter is less than 15 cm).
In order to improve the working efficiency of EPS line cutting machine equipment, auxiliary clamping and positioning work must be done before single or multiple branches are sawed together.
Strong sawing operations are not permitted. The cutting operation should be performed before the speed of the motor reaches full speed before cutting.
No one should stand in front of or to the side of the cutter. When the power is cut off, resting or leaving the workplace, the EPS line cutting machine equipment should be cut off immediately.
Do not release your hands from the operating handle until the cutter has stopped turning.
Tel:
English 
