2023.03.16
1. It is required to regularly remove the waste in the collection box to prevent too much waste from blocking the air outlet.
2. It is required to clean the cutting machine regularly every day, remove the sundries on the table, limiter and guide rail, and spray lubricating oil on the guide rail.
3. Clean the chiller regularly every half a month, drain the dirty water in the machine, and replace it with new pure water.
4. The indoor environment will have a certain impact on the life of the machine, especially the humid and dusty environment. Humid environment is easy to make the reflective lens rust, and it is also easy to cause problems such as circuit short circuit or laser discharge and ignition.
5. The reflector and focusing lens should be scrubbed with a special cleaning solution every 6-8 hours. When scrubbing, use a cotton swab or cotton swab dipped in the cleaning solution to scrub counterclockwise from the center of the focusing lens to the edge. At the same time, be careful to scratch the lens hurt.
Tel:
English 
