2022.09.13
Pre -clearing the tube of the tube, close the cleaning door, open the mixing motor, and open the air valve and steam valve. Prepare the raw materials and press the delivery button. Set the amount of the material, place the weighing switch at the automatic position, set the number of times required to set the counter, confirm the time of each step, and wait for the signal that the material is full. The fans and screening machine will automatically select the button. Press the preheating button. After preheating for 6min, according to the number of pre -issuing times, the pre -issuing machine will automatically repeat the pre -issuing process.
End of the pre -issuing end. When the last operation is over, the remaining raw materials are insufficient, and the switch is allocated to semi -automatic. Press the “remaining
Pre -issuing the “button, the remaining materials will be pre -issued within 5s shorter than the previous process. This switch is only within 50 ~ 300s in the previous operation.
Effects, you need to do manually in this range. Stop in a fully automatic mode, clean the tube manually, will stay in the pre -launched cylinder
Beads are cleared. Close the steam and air general valve to cut off the EPS pre -issued power supply.
Tel:
English 
