2022.06.09
The common problem in EPS wire cutting equipment is: the working voltage of EPS wire cutting equipment is too high and unstable, which can easily cause power failure. EPS line equipment operation time is too long, high temperature working time is too long, the equipment is easy to be brittle, and the repair rate of computer hard disk is high.
EPS foam equipment customers can also choose products based on general market prices. A reasonably priced product can not only play its role better, but also improve production efficiency. Customers can also choose appropriate products to ensure better results in cutting through comparison and selection. In short, the current sales of EPS foam equipment on the market are very good. When we choose products according to the quality and price of products, we must also master these basic methods and skills. In the process of actual operation and use, we can also see To the quality of the product, as long as the process of operation and use meets the quality requirements, you can use it with confidence.
EPS wire is a new type of exterior wall decorative wire and prefabricated component, which can replace traditional cement components, with light weight, smooth wire and small deviation. EPS line is a pattern design formed by EPS line equipment according to the synchronous action of operating X-axis and Y-axis, and cutting various products with electric heating wire. The relative path of the electronic routing device is applied to the electronic computer to input the pattern differential signal to control the X and Y axes.
Scope of application of EPS line equipment Structural features of EPS production line equipment: manual and automatic devices when stopped, manual brake red brake button. This button has no effect when the start button is pressed. After pulling the brake electromagnet, press the start button to immediately release the brake electromagnet. Equipped with removable cutting material for sizing equipment. To ensure the dimensional accuracy of the cut material, it is equipped with a digital display ruler. The movable table uses a vacuum suction method to hold the cut foam.
The EPS line CNC machine tool cutting machine is controlled by the control system, and the additional engineering drawings are applied to the CNC machine tool cutting machine CNC programming software, and can also be copied to the CAD drawing tool and the cutting system software. The graphic cutter, without compiling the whole process of the program, converts the code into a cutting machine and immediately converts it into a cutting machine for cutting CNC machine tools. The computer or programming machine can automatically carry out program writing and application, and carry out the whole process of part programming process, which is very convenient for some complicated parts.
Tel:
English 
