2022.06.06
1、 Working principle of EPS coil equipment: it is combined into graphics by controlling the synchronous operation of x-axis and y-axis, and various EPS products are cut with resistance wire at the same time. Its path is to use the image input by the computer to automatically generate pulse signals and control the X and Y axes. This machine is suitable for processing products with small size and large quantity, and has multi line NC profiling. The resistance wire cutting system can use up to 20 resistance wires at the same time. After the graphics are input into the computer, all resistance wires can be carried out in parallel. One cutting can cut 20 complex two-dimensional shapes. The key to production is the efficiency of cutting lines and the accuracy of geometric dimensions.
2、 Advantages of the network cable equipment: the network cable equipment is light in weight, fireproof, waterproof, moth proof, mould proof and crack proof. The construction is simple. It is suitable for all kinds of indoor and outdoor decorative materials. It is a new type of decorative material for energy conservation and environmental protection. At the same time, EPS line has low cost: low cost, simple decoration, finished surface spraying, sawing, nailing and sticking, saving 70% of the construction cost compared with cement and gypsum products. The construction of EPS line is simple. The shape of EPS line can be bent without cracking, deformation and moth eaten. It can be used outdoors. It can be installed and installed only by pasting. The environmental protection EPS line meets the non-toxic and harmless green product standard for engineering decoration.
In terms of its principle and advantages, EPS line devices do have some features that traditional lines do not have, and are now widely used. With the progress of science and technology, it is believed that EPS line devices will have better performance and wider users.
Secondly, let’s take a look at the composition of the CNC foam cutting machine. The CNC foam cutting machine is mainly used to complete the cutting of foam plastics through electric heating wires. What components does it consist of? The mechanical part, electrical part and software programming part mainly include the following parts, which are briefly introduced.
The mechanical components are: the fuselage, with two X axes downward and two Y axes downward. The main center of the whole equipment is the X and Y slides. Through the linkage of the two axes, the cutting of various workpieces is realized. It is mainly composed of control motor, lead screw, bracket, slide rail, etc. Its working principle is that the motor drives the lead screw to rotate through the coupling. As the nut is limited by rotation, the rotation motion becomes a linear motion. Each control shaft is equipped with an over travel switch to ensure no collision.
Introduction to the electrical part: the electrical part mainly receives computer instructions and amplifies the signal to drive the motor to rotate. It consists of the following parts: 1) the control board is the driver that directly receives the instructions sent by the computer, converts the signals into pulses and direction signals and sends them to each axis; 2) The driver receives the pulse and direction signal sent by the control board, amplifies the signal, and drives the motor to rotate; 3) Electric motor, which converts the amplified electric signal into mechanical rotation; 4) The power supply is a stable voltage, and the electrical appliance can work normally only after filtering.
Software programming part: Based on the ACD system platform widely used in the world, the operation is simple and practical. As long as you have a general 2D drawing foundation, you will soon learn to operate the computer in four steps. A. CAD drawing and tracing points, B saving files, C controlling software importing files to adjust parameters, D debugging cutting.
Through the division of labor and cooperation of these parts, the CNC foam cutting machine can effectively complete the cutting work. As it involves the software programming part, personnel training is still required before operation. At the same time, safety production is also very important. Read the safety operation procedures and product instructions carefully.
Tel:
English 
