Tel: +86-18868710888 571-81110023
ricky@epsole.com
Home
Product
Video
About us
Contact us
July
In the impact test, the experimenter will simulate the internal force of the helmet when it is impacted. A qualified helmet must keep the gravitational acceleration of its internal conduction energy within 300g. This must be achieved through the rupture or deformation of the EPS buffer layer. EPS converts a small part of the energy generated by the impact into heat, prolongs the energy transmission time, and reduces the peak energy reaching the head and brain.
eps automatic foam molding machine adopts PLC, imported touch screen, full Chinese display, intelligent graphical interface control, realizes man-machine dialogue mode.The foam molding machine can be produced in a variety of ways and can be fully automatic, semi-automatic, intermediate starting and manual operation.eps automatic foam molding machine hydraulic system is stable, low noise and large clamping force.
The common problem in EPS wire cutting equipment is: the working voltage of EPS wire cutting equipment is too high and unstable, which can easily cause power failure. The operating time of EPS line equipment is too long, the working time at high temperature is too long, the equipment is easy to be brittle, and the repair rate of computer hard disk is high. In fact, many of the reasons for the common failures of the above-mentioned EPS line equipment are caused by improper actual operation during the working day. Therefore, more attention should be paid to the maintenance of the EPS line equipment during work to avoid similar common failures.
June
E-mail
Message
Contact
Tel:
English 
