Tel: +86-18868710888 571-81110023
ricky@epsole.com
Home
Product
Video
About us
Contact us
November
Close the feeding gate (at this time, the raw materials can be filled again). The raw materials in the machine will be released in advance gradually until the overflow source flows out of the pre sent beads. Open the raw material inlet to feed continuously, and at the same time, the overflow port continuously flows out the pre sent beads. At this time, it is necessary to adjust the valve and increase the temperature to obtain the best temperature.
At present, the laser is mainly used for cutting. Since the fine cutting of the laser beam is not easy to be deformed, the incision is smooth, and the edge is not ambiguous, it is currently used in various fields. Of course, in the process of using the foam cutting machine, it will inevitably lead to failure and need to be repaired. Now we will say the following precautions during maintenance.
We must check the front and back of the foam forming machine. It is necessary to determine whether the equipment can be used normally and whether there is abnormal buzz.
When the main building planning is completed, EPS expansion polystyrene board thin plaster external wall insulation is the choice of polystyrene foam EPS mechanical foam board (hereinafter referred to as benzene) as a building insulation materials. Put the benzene board with special adhesive mortar paste the wall as needed. If you need special reinforcement, you can use plastic swollen screws to anchor. And then in the benzene board outside the application of polymer cement mortar, during which pressure into the alkali-coated fiberglass mesh to strengthen the formation of anti-cracking mortar maintenance layer, and finally for the putty and paint the decoration layer.
E-mail
Message
Contact
Tel:
English 
